Both are currently at the airport reference altitude. Below are two examples - Runways and Starts. There are a number of other parts of the airport that have an altitude that could be set differently than the airport reference altitude. But when you go back out of the edit box it places the ident number of 21 on runway 3 end and 3 on runway 21 end. It is not enough to change the reference altitude of the airport. Blastpads have yellow markings, different than the runway, and are not part of the runway and can't ever be used by any aircraft. When I edit the runway information in ADE and make 21 the primary I note that it changes the secondary to runway 3 as it should. FWIW, displaced thresholds have white markings, just like the runway, and are a part of the runway that can be used by departing aircraft. number of bug fixes and enhancements this version introduces support for FS2004 & FSX. Now that I have taken the long route to my question. Airport Design Editor Help The Airport How do I Change the Airport. 4L and 4R are used for GA and some Inter-Island departures. 8R is used for mainland and international departures exclusively. Runway 9L and 9R have been switched to the 10L and 10R. Slewing is a nice way to check out a routes terrain before flying it, or to realign your aircraft with the runway for another landing attempt. That means wind is from 360-130 deg and preferred runways are the 8s and 4s.Typically, 8L is used for Inter Island departures, and sometimes 757s going to the mainland. Im wondering if FSDT is going to update the scenery at FLL for the new runway change. Reinstalled Affected airports with latest installers and updates making sure to press yes for updated afcad no markings. Fort Lauderdale-Hollywood FSX/P3D ยป New Runway Number. ![]() Reinstalled p3dv5 Scenery and content packages still no markings. Possibly because they were relocating and lengthening the runway on the North End the Facility notices might have temporarily changed the primary to runway 3 so thus it ended up that way is FSX. Disable and restore option in envtex no markings. I have modifed the runway and I am going to recreate the airport but I note that runway 21 should be the primary but runway 3 is the primary in the sim. The runway was around 5200 feet but currently is 7800 feet including a displaced threshold on runway 3 with an 800 foot overrun I think. When I tried to change this, it place the runway in the wrong location, so I assume that I should not change the heading. I noticed that the heading says 181.72 but it's actually 186.50. Now it will compile and the runway numbers are correct. These changes at the airport took place about the time FSX was being developed. I deleted all of the runways other than runways 19L/19R, 01L/01R, and 10/28. ![]() This airport has had major changes and upgrades since FSX came out. I am using ADE to edit the stock airport in FSX for what is known as Harrison/Marion airport in the FSX search data base.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |